The Typewriter Project – The End

dsc00238I was working on my typewriter project today and had finally removed all the parts needed so that what I basicaly had was an empty frame.

One of the beams wennt into the area where the motherboard would be located and needed to be removed. This was held in place by a number of pegs. Using a hammer and an awl/center punch, I began tapping the pegs to push them out. As they wouldn’t move, I used a little more force.

And that’s when the frame broke. Both front and back, so it was now completely in two pieces. As it is made out of cast iron, the chances of getting it repaired and still look would cost many times more than I paid for the actual typewriter (which was 80 SEK).

dsc00239

Economically, it’s no biggie. It’s just the time I’ve spent on it that feels a bit sour. It took over 10 hours to get it stripped down to the state it was in before it broke.

To commemorate the moment, I took some pictures of just the screws that I removed from the typewriter when pulling it apart. Note there were more screws than this on the typewriter, including tiny calibration screws for each and every key. These are just the ones I unscrewed.

So now what?

There are a few options. Either I find another typewriter with a more suitable frame. Or I use a NES casing (I have two in storage for such a purpose). Or I build a custom case. Or I find something else to build my computer into.

Let’s see what comes my way.

guest
0 Comments
Inline Feedbacks
View all comments